STOCK CARS

50.	CARS MUST BE A PURPOSE-BUILT SPACE FRAME SINGLE SEATED OPEN WHEELED CHASSIS, FORMULA 2 TYPE ONLY AND SHALL NOT BE 
DERIVED FROM A MANUFACTURED ROAD VEHICLE.  BEAM AXLES OUTLAW SIZE ALLOWED.

51.	FOUR WHEEL DRIVE VEHICLES ARE NOT ALLOWED.

52.	ENGINES TO BE OF ANY CAPACITY AND OPEN TO ANY MODIFICATION.

53.	
a)	ALL CARS MUST BE FITTED WITH BUMPERS NOT LESS THAN 4" DEEP AND THE CENTRE BEING BETWEEN 16" AND 18" FROM THE GROUND.

b)	ROLL BARS MUST BE FITTED AND WELDED OR BOLTED SECURELY AND SAFELY.  THE ROLL BAR OVER OR TO THE REAR OF THE DRIVERS
 HEAD, SHALL BE A MINIMUM OF 1½" OR METRIC EQUIVALENT SQUARE OR ROUND SECTION AND SHALL INCLUDE AT LEAST ONE DIAGONAL 
CROSS BRACE.
c)	A FULL HARNESS MUST BE FITTED AND SECURED SAFELY.  A QUICK RELEASE STEERING WHEEL MUST BE FITTED.
d)	ANY MAKE OR COMPOUND OF TYRE MAY BE USED PROVIDED THEY ARE READILY AVAILABLE TO EVERYONE.
ALL STOCK CARS WILL DISPLAY THEIR CURRENT ROOF COLOUR ON A BOARD, THE SIZE OF A CAR NUMBER PLATE, TAPING A SECTION OF 
THE AEROFOIL WILL NOT BE SUFFICIENT.  FAILURE TO DISPLAY THESE PLATES WILL RESULT IN A TWO PLACE FORFEITURE.  A SECOND 
OFFENCE WILL RESULT IN A BAN.
e)	A BLACK AREA WILL BE PAINTED ON THE AEROFOIL TO TAKE A WHITE NUMBER OR NUMBERS OR A WHITE AREA TO TAKE BLACK NUMBERS.


54.	STOCK CARS TO HAVE STEEL SIDE PANELS, FROM THE FRONT UPRIGHT BAR OF THE CAB, TO THE REAR OF THE CAB.  THE STEEL 
PLATE SHALL BE S.W.G. 14 OR ITS EQUIVALENT 2mm THICK.  IT MAY BE FITTED UNDER EXISTING ALUMINIUM SHEET OR INSTEAD OF 
THIS SKIN.  FITTED TO BOTH SIDES OF THE CAB.  BOX SECTION MAY BE USED INSTEAD OF PLATE.

IF THE RULES DO NOT SPECIFY THAT YOU CAN, THEN TAKE IT THAT YOU CAN'T.
IF IN DOUBT TO SAVE DISAPPOINTMENT CONSULT THE SCRUTINEER AND COMMITTEE.